Motorcycle Specs

DUCATI MANUAL 999R 1 5 SCALE NITRO POWERED R C MOTORCYCLE

INSTALL the RADIO GEAR to bypass the already assembled version of the RTR
(a) install the receiver power switch next to the Steering servo servo-mount page 2 tap screws.
(b) to install the control servo servo-mount screws on the top of the faucet. (Note, the output shaft or axle is centered on the shelf between frames).
c. Install the throttle servo 4 servo-mount onto the page by tapping screws. The following location is shown in this manual.
(d) install the receiver in two of the double-sided tape, by using the frame posts.
(e) in the case of the battery to the bottom of the hull of the install. The protection of the great zip tie, then the battery.
(f) ensure that all cables are securely connected to: control servo connector plug-channel 1 and slot a connector to connect the throttle servo – channel 2 will change the battery in the connector plug to the battery slot. Then, the thread of the receiver antenna/antenna mount thread.
(g) the thread of the receiver antenna/thread., just the antenna at the end of the transfer tube and install the antenna on top of the mount of the pipe. Insert the tip of the antenna wire to secure the supply of Antenna an antenna at the top of the tube.
(h). then use small tie or zip tie to organize an additional wiring, high temperature, or moving parts.

Download